Failedtofulfilldirectivefrompdp - Cisco MCS-7825-H3-IPC1 Service Manual

Managed services guide
Table of Contents

Advertisement

Warning-Level Alarms
Recommended Action
Check if call routing response from the policy decision point complies with the guidelines specified for
external call control in the Cisco Unified Communications Manager documentation. Check if any
optional elements included as the policy obligations in the call routing response are correctly entered
according to the external call control documentation, including any applicable API documentation.

FailedToFulfillDirectiveFromPDP

Cisco Unified Communications Manager cannot fulfill the call routing directive returned by the PDP.
The failure can occur because of the following conditions:
Cisco Unified Serviceability Alarm Definition Catalog
CallManager/CallManager
Severity
Warning(4)
Routing List
SDL
SDI
Sys Log
Event Log
Parameters
Policy Decision Point(String)
Reason, Unified CM failed to fulfill the directive(String)
Called Party Number(String)
Calling Party Number(String)
Calling User Id(String)
Recommended Action
In many cases, the cause for a failure occurs because of the intervention by a CTI application which
scoops up the call before Unified CM is able to fulfill the routing directive in the PDP. Examine the CTI
application to ensure that the call is in alerting or connected state before the CTI begins to interact with
it.
If the failure is caused by a problem with the annunciator ID, ensure the ID has been accurately
configured in the PDP and that it exists in Unified CM Administration.
If the failure was caused by a lack of media resources, try increasing the Annunciator Call Count service
parameter in the Cisco IP Voice Media Streaming App service.
Cisco Unified Communications Manager Managed Services Guide
6-238
Call was cleared by a CTI application before Cisco Unified Communications Manager was able to
route it to the location defined by the PDP.
Call that was allowed by a policy server was redirected by the CTI application to a destination.
Annunciator ID was misconfigured in the PDP.
Unified CM attempted to invoke a media resource such as Annunciator but no resources were
available.
Chapter 6
Cisco Unified Serviceability Alarms and CiscoLog Messages
OL-22523-01

Advertisement

Table of Contents
loading

This manual is also suitable for:

Unified communications manager 8.5(1)

Table of Contents