Endpointunregistered - Cisco MCS-7825-H3-IPC1 Service Manual

Chapter 6 Cisco Unified Serviceability Alarms and CiscoLog Messages
1
2
3
Enum Definitions -IPv6AddressAttributes
Value
0
1
2
3
Recommended Action
Investigate any network connectivity problems in the system. It's possible that you have reached the
maximum number of devices; the Cisco Unified Communications Manager service parameter, Maximum
Number of Registered Devices, controls the number of devices allowed in the system. Taking licensing,
system hardware and other related concerns into consideration, you could increase the value of the
service parameter. Also, refer to the reason code definitions for recommended actions. No action is
required if this event was issued as a result of a normal device rehome.

EndPointUnregistered

An endpoint that has previously registered with Cisco Unified Communications Manager has
unregistered. In cases of normal unregistration with reason code 'CallManagerReset',
'CallManagerRestart', 'DeviceInitiatedReset', 'EMLoginLogout', or 'EMCCLoginLogout', the severity of
this alarm is lowered to INFORMATIONAL. An endpoint can unregister for many reasons, both
intentional, such as manually resetting the device after a configuration change, or unintentional, such as
loss of network connectivity. Other causes for this alarm could include a phone being registered to a
secondary node and then the primary node come back online, causing the phone to rehome to the primary
Cisco Unified CM node or lack of a KeepAlive being returned from the Cisco Unified CM node to which
this endpoint was registered. Unregistration also occurs if Cisco Unified CM receives a duplicate
registration request for this same device.
Cisco Unified Serviceability Alarm Definition Catalog
CallManager/CallManager
Severity
ERROR
Routing List
SDL
SDI
Sys Log
OL-22523-01
Administrative only—The device has indicated that this IPv4 address is used for
administrative communication (web interface) only
Signal only—The device has indicated that this IPv4 address is used for control
signaling only
Administrative and signal—The device has indicated that this IPv4 address is used for
administrative communication (web interface) and control signaling
Definition
Unknown—The device has not indicated what this IPv6 address is used for
Administrative only—The device has indicated that this IPv6 address is used for
administrative communication (web interface) only
Signal only—The device has indicated that this IPv6 address is used for control signaling
only
Administrative and signal—The device has indicated that this IPv6 address is used for
administrative communication (web interface) and control signaling
Cisco Unified Communications Manager Managed Services Guide
Error-Level Alarms
6-151