Ddrdown; Excessivevoicequalityreports - Cisco MCS-7825-H3-IPC1 Service Manual

Chapter 6 Cisco Unified Serviceability Alarms and CiscoLog Messages

DDRDown

This alert gets triggered when the IDSReplicationFailure alarm with alarm number 32 occurs. An auto
recover procedure runs in the background, and no action is needed.
The procedure takes about 15 minutes to finish. Check that RTMT replication status equals 2 on each
node to make sure the procedure is complete.
Table 6-33
Value
Enable Alert
Severity
Enable/Disable this
alert on the
following servers
Threshold
Duration
Frequency
Schedule
Enable E-mail
Trigger Alert Action Default

ExcessiveVoiceQualityReports

This alert gets generated when the number of QRT problems that are reported during the configured time
interval exceed the configured value. The default threshold specifies 0 within 60 minutes.
Table 6-34
Value
Enable Alert
Severity
Enable/Disable this
alert on the
following servers
Threshold
Duration
Frequency
Schedule
Enable E-mail
Trigger Alert Action Default
OL-22523-01
Default Configuration for the DDRDown RTMT Alert
Default Configuration
Selected
Critical
Enabled on listed servers
Trigger alert when following condition met:
IDSReplicationFailure alarm with alarm number 32 generated
Trigger alert immediately
Trigger up to 1 alert within 60 minutes
24 hours daily
Selected
Default Configuration for the ExcessiveVoiceQualityReports RTMT Alert
Default Configuration
Selected
Critical
Enabled on listed servers
Trigger alert when following condition met:
Number of quality reports exceeds 0 times within the last 60 minutes
Trigger alert immediately
Trigger alert on every poll
24 hours daily
Selected
Cisco Unified Communications Manager Managed Services Guide
Preconfigured CallManager Alarm Notifications
6-39