Cisco MCS-7825-H3-IPC1 Service Manual page 772

CISCO-CDP-MIB
STATUS current
DESCRIPTION
An entry (conceptual row) in the cdpInterfaceTable, containing the status of CDP on an interface.
INDEX { cdpInterfaceIfIndex }
cdpInterfaceIfIndex OBJECT-TYPE
SYNTAX Integer32 (0..2147483647)
MAX-ACCESS not-accessible
STATUS current
DESCRIPTION
The ifIndex value of the local interface. For 802.3 Repeaters on which the repeater ports do not have
ifIndex values assigned, this value is a unique value for the port, and greater than any ifIndex value
supported by the repeater; in this case, the specific port is indicated by corresponding values of
cdpInterfaceGroup and cdpInterfacePort, where these values correspond to the group number and
port number values of RFC 1516.
::= { cdpInterfaceEntry 1 }
cdpInterfaceEnable OBJECT-TYPE
SYNTAX TruthValue
MAX-ACCESS read-write
STATUS current
DESCRIPTION
An indication of whether the Cisco Discovery Protocol is currently running on this interface. This
variable has no effect when CDP is disabled (cdpGlobalRun = FALSE).
::= { cdpInterfaceEntry 2 }
cdpInterfaceMessageInterval OBJECT-TYPE
SYNTAX INTEGER (5..254)
UNITS seconds
MAX-ACCESS read-write
STATUS obsolete and replaced by cdpGlobalMessageInterval.This object should be applied to the
whole system instead of per interface.
DESCRIPTION
The interval at which CDP messages are to be generatedon this interface. The default value is 60
seconds.
Cisco Unified Communications Manager Managed Services Guide
7-130
::= { cdpInterfaceTable 1 }
CdpInterfaceEntry ::= SEQUENCE {
cdpInterfaceIfIndex Integer32,
cdpInterfaceEnableTruthValue,
cdpInterfaceMessageInterval INTEGER,
cdpInterfaceGroup Integer32,
cdpInterfacePort Integer32
}
Chapter 7 Cisco Management Information Base
OL-22523-01