Cisco MCS-7825-H3-IPC1 Service Manual page 390

Error-Level Alarms
28
29
Enum Definitions -IPAddressAttributes
Value Definition
0
1
2
3
Enum Definitions -IPV6AddressAttributes
Value
0
1
2
3
Recommended Action
Actions to take vary depending on the reason specified for the endpoint unregistration. If the reason is
ConfigurationMismatch, go to the Device Configuration page in Cisco Unified CM Administration,
make a change to the Description field for this device, click Save, then reset the device. In the case of a
network connectivity or loss of KeepAlives problem, use network diagnostic tools and the Cisco Unified
CM Reporting tool to fix any reported network or Unified CM system errors. In the case of an endpoint
rehoming to the primary Unified CM node, watch for a successful registration of the device on the
primary node. In the case of a duplicate registration request, it may be a non-malicious occurrence due
to timing of an endpoint registering and unregistering; if duplicate registration requests continue or if
the same endpoint has different IP addresses, confirm the IP address on the physical device itself by
checking the settings on the device (settings button). If unregistration of this device was expected, no
action is required. Also, refer to the reason code descriptions for recommended actions.
Cisco Unified Communications Manager Managed Services Guide
6-156
FallbackInitiated—The device has initiated a fallback and will automatically reregister to a
higher-priority Unified CM. No action is necessary.
DeviceSwitch—A second instance of an endpoint with the same device name has registered
and assumed control. No action is necessary.
Unknown—The device has not indicated what this IPv4 address is used for
Administrative only—The device has indicated that this IPv4 address is used for administrative
communication (web interface) only
Signal only—The device has indicated that this IPv4 address is used for control signaling only
Administrative and signal—The device has indicated that this IPv4 address is used for
administrative communication (web interface) and control signaling
Definition
Unknown—The device has not indicated what this IPv6 address is used for
Administrative only—The device has indicated that this IPv6 address is used for
administrative communication (web interface) only
Signal only—The device has indicated that this IPv6 address is used for control signaling only
Administrative and signal— The device has indicated that this IPv6 address is used for
administrative communication (web interface) and control signaling
Chapter 6 Cisco Unified Serviceability Alarms and CiscoLog Messages
OL-22523-01