Cisco MCS-7825-H3-IPC1 Service Manual page 760

CISCO-CCM-MIB
ccmQualityReportRequest—QRTRequest
•
ccmRouteListExhausted—RouteListExhausted
•
ccmGatewayLayer2Change—DChannelOOS, DChannelISV
•
How can different SNMP traps from Cisco Unified Communication Manager be checked?
Following is the procedure for triggering few traps:
ccmPhoneStatusUpdate trap
•
• ccmPhoneFailed trap
MediaResourceListExhausted trap
•
RouteListExhausted trap
•
Cisco Unified Communications Manager Managed Services Guide
7-118
Set ccmPhoneStatusUpdateAlarmInterv (1.3.6.1.4.1.9.9.156.1.9.4) to 30 or higher in
–
ccmAlarmConfigInfo MIB table.
Disconnect a ccm server that your phones are pointing to.
–
Phones will unregister.
–
Connect the ccm server again.
–
Phones will re-register.
–
Will get the ccmPhoneStatusUpdate trap.
–
– Set ccmPhoneFailedAlarmInterval (1.3.6.1.4.1.9.9.156.1.9.2) to 30 or higher in
ccmAlarmConfigInfo MIB table.
Make a phone fail. Delete a phone from CM and register the phone again.
–
– For phone failed traps two different scenarios can be tried:
Set the phone to point to tftp/ccm server A. plugin the phone to ccm server B on different
switch. The phone status is unknown. Will see following: 2007-10-31:2007-10-31 14:53:40
Local7.Debug 172.19.240.221 community=public, enterprise=1.3.6.1.4.1.9.9.156.2.0.2,
enterprise_mib_name=ccmPhoneFailed, uptime=7988879, agent_ip=128.107.143.68,
version=Ver2, ccmAlarmSeverity=error, ccmPhoneFailures=1.
Register a 7960 phone as 7940 phone in the Cisco Unified CM and thus cause the db issue
that makes the phone fail trap.
Create a Media Resource Group (MRG), have it contains one of the standard ConferenceBridge
–
resource (CFB-2).
Create a Media Resource Group List (MRGL), have it contains the MRG just created.
–
In the Phone Configuration page for real phones, set MRGL as the phone Media Resource
–
Group List.
Stop the IPVMS which make the ConferenceBridge resource (CFB-2) stop working.
–
Make conference calls with phones that using the media list, you will see "No Conference
–
Bridge available" in the phone screen.
Then check if a "MediaListExhausted" Alarm/Alert/Trap is generated.
–
Create a Route Group (RG), have it contains one Gateway.
–
Create a Route Group List (RGL), have it contains the RG just created.
–
Create a Route Pattern (9.XXXX) that reroute a 9XXXX call through the RGL.
–
Unregister the gateway.
–
Chapter 7 Cisco Management Information Base
OL-22523-01