Cisco MCS-7825-H3-IPC1 Service Manual page 660

Chapter 7 Cisco Management Information Base
CISCO-CCM-MIB
callManagerRestart: A device restart was initiated from Cisco Unified CM Administration, either
due to an explicit command from an administrator or due to a configuration change such as adding,
deleting or changing a directory number associated with the device.
duplicateRegistration: Cisco Unified CM detected that the device attempted to register to two nodes
at the same time. Cisco Unified CM initiated a restart to the phone to force it to re-home to a single
node.
callManagerApplyConfig: Cisco Unified CM configuration is changed.
deviceNoResponse: Device is not responding Service Control Notify from Cisco Unified CM.
emLoginLogout: The device has been unregistered due to an Extension Mobility login or logout.
emccLoginLogout: The device has been unregistered due to an Extension Mobility Cross Cluster
login or logout.
powerSavePlus: The device powered off as a result of the Power Save Plus feature that is enabled
for this device. When the device powers off, it remains unregistered from Cisco Unified CM until
the Phone On Time defined in the Product Specific Configuration for this device.
callManagerForcedRestart: (SIP Only) The device did not respond to an Apply Config request and
as a result, Cisco Unified CM had sent a restart request to the device. The device may be offline due
to a power outage or network problem. Confirm that the device is powered-up and that network
connectivity exists between the device and Cisco Unified CM.
sourceIPAddrChanged: (SIP Only) The device has been unregistered because the IP address in the
Contact header of the REGISTER message has changed. The device will be automatically
reregistered. No action is necessary.
sourcePortChanged: (SIP Only) The device has been unregistered because the port number in the
Contact header of the REGISTER message has changed. The device will be automatically
reregistered. No action is necessary.
registrationSequenceError: (SCCP only) A device requested configuration information from the
Cisco Unified CM at an unexpected time. The Cisco Unified CM no longer had the requested
information in memory.
invalidCapabilities: (SCCP only) The Cisco Unified CM detected an error in the updated media
capabilities reported by the device. The device reported the capabilities in one of the
StationUpdateCapabilities message variants.
fallbackInitiated: The device has initiated a fallback and will automatically reregister to a
higher-priority Cisco Unified CM. No action is necessary.
deviceSwitch: A second instance of an endpoint with the same device name has registered and
assumed control. No action is necessary.
SYNTAX INTEGER {
noError(0),
unknown(1),
noEntryInDatabase(2),
databaseConfigurationError(3),
deviceNameUnresolveable(4),
maxDevRegExceeded(5),
connectivityError(6),
initializationError(7),
Cisco Unified Communications Manager Managed Services Guide
7-18
OL-22523-01