Devicepartiallyregistered - Cisco MCS-7825-H3-IPC1 Service Manual

Managed services guide
Table of Contents

Advertisement

Warning-Level Alarms
Code
17
18
19
20
Recommended Action
Verify that the IP address or hostname of the image download server (either the Load server or the TFTP
server) is correct. If you're using a hostname, verify that the Domain Name Server (DNS) is accessible
from the phone and can resolve the hostname. Verify that the TFTP service is activated and running on
the Load server or TFTP server (the server you are using to serve firmware load files). Verify that the
Load server or TFTP server is accessible from the phone. Also, refer to the reason code descriptions for
recommended actions.

DevicePartiallyRegistered

Device partially registered. A device is partially registered with Cisco CallManager. Some, but not all,
of the lines configured on the device have successfully registered.
History
Cisco Unified Communications
Release
8.0(1)
Facility/Sub-Facility
CCM_CALLMANAGER-CALLMANAGER
Cisco Unified Communications Manager Managed Services Guide
6-218
Definition
The DNS server name that the phone is attempting to connect to could not be resolved.
Examine the DNS server name(s) in the phone settings to verify that the information is
accurate and if not, update the name on the phone. Restart the phone unless the restart
occurs automatically.
No DNS server - Configure a DNS server IP address on the phone settings. Restart the
phone unless the restart occurs automatically.
Connection to the Load server or TFTP server has timed out - The phone attempted to
connect to the Load server or TFTP server but could not connect successfully. If you are
using the TFTP server to serve firmware loads, check the TFTP server IP address as
configured in the settings on the phone; make sure the IP address is accurate. If it is not,
correct the IP address and press Apply; the phone should restart automatically. If you are
using a Load server to serve firmware loads, check the IP address or hostname on the
Phone Configuration page in Cisco Unified CM Administration for the phone identified in
this alarm, to ensure that the information is accurate. If it is not, update the IP address or
hostname and restart the phone. Also, verify that network connectivity exists between the
phone and the Load server or TFTP server. Restart the phone to attempt connection again
unless the restart occurs automatically.
Download was cancelled - A previous download request was superseded by a new
download request. The original download was cancelled so that the new download could
continue. No action is required.
Action
Following information is updated:
Chapter 6
Cisco Unified Serviceability Alarms and CiscoLog Messages
Enum Definitions for performance monitor object type
Enum Definitions for DeviceType
OL-22523-01

Advertisement

Table of Contents
loading

This manual is also suitable for:

Unified communications manager 8.5(1)

Table of Contents