Cisco MCS-7825-H3-IPC1 Service Manual page 838

RFC1213-MIB (MIB-II)
An estimate of the interface current bandwidth in bits per second. For interfaces which do not vary
in bandwidth or for those where no accurate estimation can be made, this object should contain the
nominal bandwidth.
::= { ifEntry 5 }
ifPhysAddress OBJECT-TYPE
SYNTAX PhysAddress
ACCESS read-only
STATUS mandatory
DESCRIPTION
The interface address at the protocol layer immediately below the network layer in the protocol
stack. For interfaces which do not have such an address (e.g., a serial line), this object should
contain an octet string of zero length.
::= { ifEntry 6 }
ifAdminStatus OBJECT-TYPE
SYNTAX Integer { up(1), ready to pass packets down(2), testing(3) in some test mode }
ACCESS read-write
STATUS mandatory
DESCRIPTION
The desired state of the interface. The testing(3) state indicates that no operational packets can be
passed.
::= { ifEntry 7 }
ifOperStatus OBJECT-TYPE
SYNTAX INTEGER { up(1),
unknown(4), dormant(5) }
ACCESS read-only
STATUS mandatory
DESCRIPTION
The current operational state of the interface. The testing(3) state indicates that no operational
packets can be passed.
::= { ifEntry 8 }
ifLastChange OBJECT-TYPE
SYNTAX TimeTicks
ACCESS read-only
STATUS mandatory
DESCRIPTION
The value of sysUpTime at the time the interface entered its current operational state. If the current
state was entered prior to the last re- initialization of the local network management subsystem, then
this object contains a zero value.
::= { ifEntry 9 }
ifInOctets OBJECT-TYPE
Cisco Unified Communications Manager Managed Services Guide
8-34
Chapter 8 Industry-Standard Management Information Base
-- ready to pass packets down(2), testing(3), -- in some test mode
OL-22523-01