Table of Contents
Advertisement
Warning-Level Alarms
30027
30028
30032
30035
Recommended Action
In the Cisco Unified Reporting tool, run the Unified CM Multi-Line Devices report and check the
number of lines that are supposed to be configured on the device identified in this alarm. If the device
has registered an inconsistent number of lines compared the Multi-Lines report for this device, restart
the device so that it can reregister all lines. If this alarm persists, verify that the appropriate number of
lines has been configured on the device, and that the appropriate directory numbers have been
configured. If the device is a third-party SIP phone, verify that the directory numbers configured on the
phone match the directory numbers configured on the device in Unified CM Administration.
DeviceTransientConnection
A connection was established and immediately dropped before completing registration. Incomplete
registration may indicate that a device is rehoming in the middle of registration. The alarm could also
indicate a device misconfiguration, database error, or an illegal/unknown device trying to attempt a
connection. Network connectivity problems can affect device registration, or the restoration of a primary
Unified CM may interrupt registration.
History
Cisco Unified Communications
Release
8.0(1)
7.1
Cisco Unified Communications Manager Managed Services Guide
6-222
ANALOG_PHONE
ISDN_BRI_PHONE
SCCP_GATEWAY_VIRTUAL_PHONE
IP_STE
Action
•
•
IPv6 parameters added: IPV6Address[Optional][String],
IPAddrAttributes[Optional][Enum], and
IPV6AddrAttributes[Optional][Enum].
Chapter 6
Cisco Unified Serviceability Alarms and CiscoLog Messages
Severity changed from Error to Warning.
Following information is updated:
Enum Definitions for DeviceType
-
Enum Definitions
-
Enum Definitions for IPAddrAttributes
-
Enum Definitions for IPV6AddrAttributes
-
OL-22523-01
Advertisement
Chapters
Table of Contents
Troubleshooting
