Cisco MCS-7825-H3-IPC1 Service Manual page 658

CISCO-CCM-MIB
–
–
–
autoRegisterDBError—Auto-registration of a device failed for one of the following reasons:
–
–
dbAccessError: Device registration failed because of an error that occurred while building the
station registration profile. This usually indicates a synchronization problem with the database
autoRegisterDBConfigTimeout: (SCCP only) The Cisco Unified CM timed out during
auto-registration of a device. The registration profile of the device did not get inserted into the
database in time. The device will automatically attempt to register again
deviceTypeMismatch: The device type reported by the device does not match the device type
configured on the Cisco Unified CM addressingModeMismatch: (SCCP only) The Cisco Unified
CM detected an error related to the addressing mode configured for the device. One of the following
errors were detected:
–
–
SYNTAX INTEGER {
noError(0),
unknown(1),
noEntryInDatabase(2),
databaseConfigurationError(3),
deviceNameUnresolveable(4),
maxDevRegExceeded(5),
connectivityError(6),
initializationError(7),
deviceInitiatedReset(8),
callManagerReset(9),
authenticationError(10),
invalidX509NameInCertificate(11),
invalidTLSCipher(12),
directoryNumberMismatch(13),
malformedRegisterMsg(14),
protocolMismatch(15),
deviceNotActive(16),
authenticatedDeviceAlreadyExists(17),
obsoleteProtocolVersion(18),
Cisco Unified Communications Manager Managed Services Guide
7-16
The device established a secure connection, yet reported that it does not have the ability to do
authenticated signaling.
The device did not establish a secure connection, but the security mode configured for the
device indicates that it should have done so.
The device established a secure connection, but the security mode configured for the device
indicates that it should not have done so.
Auto-registration is not allowed for the device type.
An error occurred while adding the auto-registering device to the database (stored procedure).
The device is configured to use only IPv4 addressing, but did not specify an IPv4 address.
The device is configured to use only IPv6 addressing, but did not specify an IPv6 address.
Chapter 7 Cisco Management Information Base
OL-22523-01