3Com MSR 50 Series Configuration Manual page 763

Configuring the RTC Receiver (RTC Server)
Follow these steps to perform basic RTC receiver (RTC server) configuration:
To do...
Enter system view
Enable terminal access rta server enable
Configure the listening
port
Create a terminal
template and enter
terminal template view
Create a RTC server
VTY
Exit terminal template
view
Enter interface view
Configure the
asynchronous serial
interface to operate in
the flow mode
Apply the template to
an interface
Exit interface view.
Enter TTY user
interface view
Enable software flow
control of the data on
the current user
interface
n
For details about the async mode flow command, refer to the async mode
■
command in
After a template is applied on an interface, you need to set the flow control
■
mode of the user interface corresponding to the interface to software flow
control. You can use the display user-interface command to display the
associations between interfaces and user interfaces.
For details about the user-interface command, refer to the user-interface
■
command in
For details about the flow-control software command, refer to the
■
flow-control command in
Perform these steps to perform advanced RTC receiver (RTC server) configuration:
Use the command...
system-view
rta rtc-server listen-port
port-number
rta template template-name
vty vty-number rtc-server remote
ip-address terminal-number
quit
interface interface-type
interface-number
async mode flow
rta terminal template-name
terminal-number
quit
user-interface { first-num1
[ last-num1 ] | tty first-num2
[ last-num2 ] }
flow-control software
"WAN Interface Configuration" on page
"User Interface Configuration" on page
"User Interface Configuration" on page
RTC Terminal Access Configuration
Remarks
-
Required
Required
Not configured by default
Required
Required
After this configuration, the
template cannot be configured
with any TTY, Telnet, or RTC
client VTYs.
-
Required
The interface type must be
supported by terminal access.
Required
By default, an asynchronous
serial interface operates in the
protocol mode and an AUX
interface the flow mode.
Required
-
-
Required
By default, the flow control
mode is none; that is, no flow
control is implemented.
99.
2155.
763
2155.