Sdi Status Display - Siemens SINAMICS S200 Operating Instructions Manual

System messages
11.1 SDI Status
RDY COM Description
Converter detection via DCP flashing
Orange
Commissioning or restore factory settings via commission‐
ing tool
Orange
Table 11-3 Signal states of RDY and COM LEDs during firmware update
RDY COM Description
Firmware update in progress
Green Green
Firmware update signals an error.
Red
Firmware update is completed.
The converter is waiting.
Green
Please contact Technical Support for LED states that are not described above.
11.1.3

SDI Status display

Description
Display Example
8.8.8.8.8.8.
Fxxxxx
F.xxxxx.
Fxxxxx.
316
Description
Converter is in startup state
Fault code
Fault code of the first fault
Fault code
SINAMICS S200 pulse train servo drive system with SIMOTICS S-1FL2
Remedy
-
-
Remedy
-
• Switch the converter supply voltage
off and on, and repeat the firmware
update.
• Firmware update via memory card:
Replace memory card and repeat firm‐
ware update.
• Contact Support/Hotline.
Switch the converter supply voltage off
and on.
-
In the case of a single fault
In the case of multiple faults
In the case of multiple faults
Operating Instructions, 11/2023, FW V6.3, A5E51646767B AA
Remarks