Table of Contents
Advertisement
System messages
11.3 Faults and alarms
Cause:
Communications error with an EEPROM or an analog/digital converter.
Fault value (r0949, interpret hexadecimal):
80000000 hex:
- Internal software error.
00000001 hex ... 0000FFFF hex:
- Module fault.
Remedy:
For fault value = 80000000 hex:
- Upgrade firmware to later version.
For fault value = 00000001 hex ... 0000FFFF hex:
- Replace the module.
F30907
Power unit: FPGA configuration unsuccessful
Message class:
Hardware/software error (1)
Message value:
-
Component:
Power Unit
Response:
OFF2
Acknowledgment: IMMEDIATELY
Cause:
During initialization within the power unit, an internal software error has occurred.
Remedy:
- If required, upgrade the firmware in the power unit.
- Replace power unit.
- Contact Technical Support.
A30919
Power unit: Temperature monitoring failed
Message class:
Overtemperature of the electronic components (6)
Message value:
%1
Component:
Power Unit
Response:
NONE
Acknowledgment: NONE
Cause:
The temperature monitoring in the power unit has failed.
Fault-free operation of the drive system is no longer guaranteed.
Alarm value (r2124, interpret binary):
Bit 0: Sensor 1 for the internal temperature can no longer be evaluated.
Bit 1: Sensor 2 for the internal temperature can no longer be evaluated.
Remedy:
Replace the power unit immediately.
F30950
Power unit: Internal software error
Message class:
Hardware/software error (1)
Message value:
%1
Component:
Power Unit
Response:
OFF2
Acknowledgment: POWER ON
Cause:
An internal software error has occurred.
Fault value (r0949, interpret decimal):
Information about the fault source.
Only for internal Siemens troubleshooting.
Remedy:
- If necessary, upgrade the firmware in the power unit to a later version.
- Contact Technical Support.
468
SINAMICS S200 pulse train servo drive system with SIMOTICS S-1FL2
Operating Instructions, 11/2023, FW V6.3, A5E51646767B AA
Advertisement
Table of Contents
