Table of Contents
Advertisement
System messages
11.3 Faults and alarms
Acknowledgment: POWER ON
Cause:
The processor clock signal monitoring has signaled an error. This can involve the signal itself or its PLL.
Remedy:
- Replace the hardware.
- Contact Technical Support.
F30820
Power unit: Telegram error
Message class:
Internal (DRIVE-CLiQ) communication error (12)
Message value:
Component number: %1, fault cause: %2
Component:
Power Unit
Response:
OFF2
Acknowledgment: IMMEDIATELY
Cause:
Internal communications error.
Error cause:
1 (= 01 hex):
Checksum error (CRC error).
2 (= 02 hex):
Telegram is shorter than specified in the length byte or in the receive list.
3 (= 03 hex):
Telegram is longer than specified in the length byte or in the receive list.
4 (= 04 hex):
The length of the receive telegram does not match the receive list.
5 (= 05 hex):
The type of the receive telegram does not match the receive list.
6 (= 06 hex):
The address of the component in the telegram and in the receive list do not match.
7 (= 07 hex):
A SYNC telegram is expected - but the received telegram is not a SYNC telegram.
8 (= 08 hex):
No SYNC telegram is expected - but the received telegram is one.
9 (= 09 hex):
The error bit in the receive telegram is set.
16 (= 10 hex):
The receive telegram is too early.
Note regarding the message value:
The individual information is coded as follows in the message value (r0949/r2124):
0000yyxx hex: yy = component number, xx = error cause
Remedy:
- Carry out a POWER ON (switch-off/switch-on).
- Check the electrical cabinet design and cable routing for EMC compliance.
F30835
Power unit: Cyclic data transfer error
Message class:
Internal (DRIVE-CLiQ) communication error (12)
Message value:
Component number: %1, fault cause: %2
Component:
Power Unit
Response:
OFF2
Acknowledgment: IMMEDIATELY
462
SINAMICS S200 pulse train servo drive system with SIMOTICS S-1FL2
Operating Instructions, 11/2023, FW V6.3, A5E51646767B AA
Advertisement
Table of Contents
