Table of Contents
Advertisement
Response:
OFF2
Acknowledgment: POWER ON
Cause:
Insufficient processing time is available for the existing topology.
Fault value (r0949, interpret hexadecimal):
Only for internal Siemens troubleshooting.
Remedy:
- Reduce the number of drives.
F01250
EEPROM incorrect read-only data
Message class:
Hardware/software error (1)
Message value:
%1
Component:
Control Unit (CU)
Response:
NONE
Acknowledgment: POWER ON
Cause:
Error when reading the read-only data of the EEPROM in the converter.
Fault value (r0949, interpret decimal):
Only for internal Siemens troubleshooting.
Remedy:
- Carry out a POWER ON (switch-off/switch-on).
- Replace the converter.
A01251
CU: CU-EEPROM incorrect read-write data
Message class:
Hardware/software error (1)
Message value:
%1
Component:
Control Unit (CU)
Response:
NONE
Acknowledgment: NONE
Cause:
Error when reading the read-write data of the EEPROM in the converter.
Alarm value (r2124, interpret decimal):
Only for internal Siemens troubleshooting.
Remedy:
For alarm value r2124 < 256, the following applies:
- Carry out a POWER ON (switch-off/switch-on).
- Replace the converter.
For alarm value r2124 >= 256, the following applies:
- For the converter with this alarm, clear the fault memory (p0952 = 0).
- Replace the converter.
F01255
CU: Option Board EEPROM read-only data error
Message class:
Hardware/software error (1)
Message value:
%1
Component:
None
Response:
NONE
Acknowledgment: POWER ON
Cause:
Error when reading the read-only data of the EEPROM in the Option Board.
Fault value (r0949, interpret decimal):
Only for internal Siemens troubleshooting.
Remedy:
- Carry out a POWER ON (switch-off/switch-on).
- Replace the Control Unit.
A01256
CU: Option Board EEPROM read-write data error
Message class:
Hardware/software error (1)
SINAMICS S200 pulse train servo drive system with SIMOTICS S-1FL2
Operating Instructions, 11/2023, FW V6.3, A5E51646767B AA
System messages
11.3 Faults and alarms
347
Advertisement
Table of Contents
