Table of Contents
Advertisement
Technical data
13.2 Technical data of the motor
Table 13-21
Vibration velocity V
ISO 10816
Max. 4.5 mm/s
To evaluate the vibration velocity, the measuring equipment must meet the requirements of
ISO 2954.
Select the measuring locations according to ISO 10816-1, Section 3.2. See the illustration
below for more information on the measuring points.
①
②
③
The vibration acceleration is evaluated in the frequency range from 10 Hz to 2000 Hz. The
maximum peak in the measurement time range is considered.
The vibration values must not exceed the specified limits at any measuring location.
13.2.9
Shaft extension
Technical data
The motors are supplied with cylindrical shaft extensions. The shaft extension usually has a
centering thread according to DIN 332, form DR.
Optionally, a shaft extension with key slot and feather key is available.
526
Vibration values for motors with high inertia
to
Vibration acceleration a
rms
25 m/s
End shield DE radial
End shield DE radial
End shield DE axial
axial
peak
2
④
End shield NDE radial
⑤
End shield NDE axial
⑥
End shield NDE radial
SINAMICS S200 pulse train servo drive system with SIMOTICS S-1FL2
Operating Instructions, 11/2023, FW V6.3, A5E51646767B AA
Vibration acceleration a
peak
dial
50 m/s
2
ra‐
Advertisement
Table of Contents
