Table of Contents
Advertisement
System messages
11.3 Faults and alarms
Remedy:
- Check the main circuit fuses.
- Check whether a single-phase load is distorting the line voltages.
- Detune the resonant frequency with the line inductance by using an upstream line reactor.
- Dampen the resonant frequency with the line inductance by switching over the DC link voltage compensation in the
software or increase the smoothing. However, this can have a negative impact on the torque ripple at the motor output.
- Check the motor feeder cables.
F30012
Power unit: Temperature sensor wire breakage
Message class:
Power electronics faulted (5)
Message value:
%1
Component:
Power Unit
Response:
OFF1
Acknowledgment: IMMEDIATELY
Cause:
The connection to a temperature sensor in the power unit is interrupted.
Fault value (r0949, interpret binary):
Bit 1: Air intake
Bit 2: Inverter 1
Bit 3: Inverter 2
Bit 4: Inverter 3
Bit 5: Inverter 4
Bit 6: Inverter 5
Bit 7: Inverter 6
Bit 8: Rectifier
Bit 10: Moisture ext. moisture sensor
Bit 11: Temperature ext. moisture sensor
Bit 13: Balance resistor
Bit 14: Capacitor air discharge
Bit 15: Liquid intake
Remedy:
Contact Technical Support.
F30013
Power unit: Temperature sensor short-circuit
Message class:
Power electronics faulted (5)
Message value:
%1
Component:
Power Unit
Response:
OFF1
Acknowledgment: IMMEDIATELY
Cause:
A temperature sensor in the power unit is short-circuited.
Fault value (r0949, interpret binary):
Bit 1: Air intake
Bit 2: Inverter 1
Bit 3: Inverter 2
Bit 4: Inverter 3
Bit 5: Inverter 4
Bit 6: Inverter 5
Bit 7: Inverter 6
Bit 8: Rectifier
Bit 10: Moisture ext. moisture sensor
Bit 11: Temperature ext. moisture sensor
Bit 14: Capacitor air discharge
Bit 15: Liquid intake
Remedy:
Contact Technical Support.
436
SINAMICS S200 pulse train servo drive system with SIMOTICS S-1FL2
Operating Instructions, 11/2023, FW V6.3, A5E51646767B AA
Advertisement
Table of Contents
