Siemens SINAMICS S200 Operating Instructions Manual page 680

Appendix
A.3 Parameters
Min:
0 [ms]
Description: Sets the time delay for detecting the line voltage failure.
The function must be activated via p2149.16.
Dependency: See also: p2149
See also: F30265
r3988 Final boot state
Data type: Integer16
Read permission:
Write permission:
Parameter group:
Unit: -
Description: Displays the final boot states.
001 - Software error
200 - Carry out first commissioning
250 - Topology error (check the connected hardware)
800 - Ready
The following options are available to reach the "Ready" state:
- Check the project and load again.
- Restore factory setting.
- Check the hardware.
- Carry out a POWER ON (switch-off/switch-on).
p4405 PTO maximum output frequency
Data type: FloatingPoint32
Read permission:
Write permission:
Can be changed in the operating
state:
Parameter group:
Unit: kHz
Min:
1 [kHz]
Description: Sets the maximum output frequency for encoder emulation.
NOTICE
The hardware is designed for a maximum PTO output frequency of 4 MHz. To tolerate any overshoot as a result of the
motor control, p4405 can be set approximately 10 % above 4 MHz.
p4408 PTO pulse number
Data type: Unsigned32
Read permission:
Write permission:
Can be changed in the operating
state:
Parameter group:
Unit: -
Min:
0
Description: Sets the pulse number output from the PTO.
678
Max:
100 [ms]
Visible in: Extended display
Read drive data or acknowledge messages
Edit device configuration or drive applications
System identification
Visible in: Standard display
Read drive data or acknowledge messages
Edit device configuration or drive applications
Commissioning
Pulse encoder emulation
Max:
5000 [kHz]
Visible in: Standard display
Read drive data or acknowledge messages
Edit device configuration or drive applications
Commissioning
Pulse encoder emulation
Max:
16777216
SINAMICS S200 pulse train servo drive system with SIMOTICS S-1FL2
Operating Instructions, 11/2023, FW V6.3, A5E51646767B AA
Factory setting:
10 [ms]
Factory setting:
1000 [kHz]
Factory setting:
1024