Table of Contents
Advertisement
Description
3.5 Directives and standards
Motor requirements
Affected Siemens products
Figure 3-13
The article number
the article number of the SIMOTICS S-1FL2 motor.
Certificates for download
You can find all relevant certificates for download on the Internet:
3.5.3
Directives, standards and certificates for the MOTION-CONNECT cable
The following directives and standards are relevant for the MOTION-CONNECT cables:
European Low Voltage Directive
The MOTION-CONNECT cables fulfill the requirements stipulated in the Low-Voltage Directive
2014/35/EU, if they are covered by the application area of this directive.
European Machinery Directive
The MOTION-CONNECT cables fulfill the requirements stipulated in the Machinery Directive
2006/42/EC, if they are covered by the application area of this directive.
However, the use of the converters and motors in a typical machine application has been
fully assessed for compliance with the main regulations in this directive concerning health
and safety.
European RoHS Directive
The MOTION-CONNECT cables comply with Directive 2011/65/EU regarding limiting the use
of certain hazardous substances.
European EMC Directive
The compliance of the MOTION-CONNECT cables with the regulations of the Directive
2014/30/EU has been verified through full compliance with the IEC/EN 61800-3.
72
Example of the China Energy Label
①
stated on the China Energy Label corresponds to the first 11 digits of
Certificates (https://support.industry.siemens.com/cs/ww/en/ps/29685/cert)
As of the implementation date of the standard, all affected motors must
be provided with the "China Energy Label".
Affected Siemens motors are subject to the requirements of standard
GB30253-2013: SIMOTICS S-1FL2 servo motors.
SINAMICS S200 pulse train servo drive system with SIMOTICS S-1FL2
Operating Instructions, 11/2023, FW V6.3, A5E51646767B AA
Advertisement
Table of Contents
