Siemens SINAMICS S200 Operating Instructions Manual page 589

The following write permissions are available:
• Control drive in manual mode
• Perform drive diagnostics
• Perform firmware update
• Create backup or load drive data to the commissioning tool
• Edit device configuration or drive applications
• Edit web server configuration
• Manage users and roles
Runtime function rights depend on user roles, which are assigned in the commissioning tool
being used. As a consequence, setting parameters can be write-protected.
The commissioning tool provides additional support.
Can be changed in the operating state
A parameter can only be changed in this operating state. The change only becomes active
after exiting the state.
The following states exist:
• Operation
The pulses have been enabled.
• Ready for operation
The pulses are not enabled and state "Commissioning" is not active.
• Commissioning
Commissioning takes place.
The pulses cannot be enabled.
Parameter group
A parameter group contains parameters that are functionally associated with one another.
Unit
Shows the default unit of the parameter. For adjustable parameters, the unit is additionally
specified according to the values (Min, Max, Factory setting) in square brackets.
Min, Max, Factory setting
The parameter value "when shipped" is specified under "Factory setting" with the relevant
unit in square parentheses.
The value can be adjusted within the range defined by "Min" and "Max".
This information is not applicable for display parameters.
Min
Max
Factory setting
SINAMICS S200 pulse train servo drive system with SIMOTICS S-1FL2
Operating Instructions, 11/2023, FW V6.3, A5E51646767B AA
Minimum value of the parameter [unit]
Maximum value of the parameter [unit]
Value when delivered [unit]
Appendix
A.3 Parameters
587