Table of Contents
Advertisement
System messages
11.3 Faults and alarms
25
X205
40
X400
41
X401
42
X402
50
X500
51
X501
52
X502
53
X503
54
X504
55
X505
56
X506
57
X507
Cause:
The topology comparison has detected an encoder that is missing in the actual topology with respect to the target topology.
Alarm value (r2124, interpret hexadecimal):
ddccbbaa hex:
dd = connection number (%4)
cc = component number (%3)
bb = component class (%2)
aa = component number of the component that has not been inserted (%1)
Note:
The component is described in dd, cc and bb, where the component has not been inserted.
Component class and connection number are described in F01375.
Remedy:
Adapting topologies:
- Insert the components involved at the right connection (correct the actual topology).
- Adapt the project/parameterizing in the commissioning tool (correct the target topology).
Check the hardware:
- Check the 24 V supply voltage.
- Check cables for interruption and contact problems.
- Check that the component is working properly.
Note:
Under "Topology --> Topology view" the commissioning tool where relevant offers improved diagnostics capability (e.g.
setpoint/actual value comparison).
A01489
Topology: Motor not connected
Message class:
Error in the parameterization / configuration / commissioning procedure (18)
Message value:
Component: %1, to %2, %3, connection: %4
Component:
None
Response:
NONE
366
SINAMICS S200 pulse train servo drive system with SIMOTICS S-1FL2
Operating Instructions, 11/2023, FW V6.3, A5E51646767B AA
Advertisement
Table of Contents
