Connecting
6.6 Connecting the braking resistor
4. Remove the blanking plug from R1 and insert it into R2.
5. Connect the external braking resistor cable to terminals DCP and R1 as shown below:
More information
For more information about cable requirements, see Section "Cables and connectors
(Page 124)".
For more information about assembling cable terminals, see Section "Assembling cables
(Page 734)".
144
SINAMICS S200 pulse train servo drive system with SIMOTICS S-1FL2
Operating Instructions, 11/2023, FW V6.3, A5E51646767B AA