System-Stopped Replacement - Oracle Fujitsu SPARC M12-1 Service Manual

7.2.2

System-Stopped Replacement

This section describes the workflows for system-stopped/hot and system-stopped/
cold FRU replacement. References to detailed descriptions are written in the
workflow. See any of them as required.
Note - If the XSCF startup mode is high-speed mode, hardware cannot be replaced using the
replacefru command. Replace hardware by performing system-stopped/cold replacement.
System-stopped replacement on the SPARC M12-1 has the following patterns:
System-stopped/hot replacement (PSU and FANU)
■
System-stopped/hot replacement (HDD/SSD)
■
System-stopped/cold replacement
■
Chapter 7 Maintenance Flow 99