Oracle Ilom System Console - Oracle SPARC S7-2L Installation Manual

7. Continue with the installation by powering on the server for the first time.
See "Powering On the Server for the First Time" on page
Related Information
"Connect the SER MGT Cable" on page 67
■
"Configure the Preinstalled OS" on page 82
■
"Reach a State to Install a Fresh OS (Oracle ILOM CLI)" on page 82
■
"Reach a State to Install a Fresh OS (Oracle ILOM Web Interface)" on page 84
■

Oracle ILOM System Console

When you power on the server, the boot process begins under the control of the Oracle ILOM
system console. The system console displays status and error messages generated by firmware-
based tests that are run during system startup.
Note -
SER MGT before applying power to the server. See
SER MGT Port" on page
After the system console finishes its low-level system diagnostics, the SP initializes and runs a
suite of higher level diagnostics. When you access the SP using a device connected to the SER
MGT port, you see the output of the Oracle ILOM diagnostics.
By default, the SP configures the NET MGT port automatically, retrieving network
configuration settings using DHCP and allowing connections using SSH.
For a more detailed discussion on configuring the system console and connecting terminals,
refer to the administration guide for your server.
Related Information
SPARC and Netra SPARC S7-2 Series Servers Administration Guide
■
Oracle ILOM documentation
■
"Configure the Preinstalled OS" on page 82
■
"Reach a State to Install a Fresh OS (Oracle ILOM CLI)" on page 82
■
"Reach a State to Install a Fresh OS (Oracle ILOM Web Interface)" on page 84
■
"Assign a Static IP Address to the NET MGT Port" on page 87
■
To see these status and error messages, connect a terminal or terminal emulator to the
77.
Oracle ILOM System Console
75.
"Connect a Terminal or Emulator to the
Powering On the Server for the First Time 79