Required Tools; Preparing The Server For Component Replacement - Oracle X8-2L Service Manual

Required Tools

When a server FRU that contains the KIP is removed and a replacement component is installed,
the KIP of the replacement component is programmed by Oracle ILOM to contain the same
KIP as the other two components.
Note -
be completed when two of the three quorum members contain matching key identity properties.
Related Information
"Servicing Power Supplies (CRU)" on page 93
■
"Servicing the Disk Backplane (FRU)" on page 159
■
"Servicing the Motherboard Assembly (FRU)" on page 203
■
Required Tools
The server can be serviced with the following tools:
Antistatic wrist strap
■
Antistatic mat
■
No. 2 Phillips screwdriver
■
Torx (6 lobe) T10, T15, T25, and T30 screwdrivers
■
12.0 in-lbs/ft (inch-pounds/foot) torque driver
■
Related Information
"Preparing for Service" on page 51
■

Preparing the Server for Component Replacement

Note -
are necessary. See the replacement procedures for those components for more information.
Before you can remove and install components that are inside the server, you must perform the
procedures in some or all of the following sections:
54 Oracle Server X8-2L Service Manual • January 2021
Only one of the quorum members can be replaced at a time. Automated updates can only
When you are replacing the storage drives or power supplies, not all of these procedures