Sas Port - Oracle Fujitsu SPARC M12-1 Service Manual

Table D-3 USB 3.0 Port (Rear) (continued)
Pin Arrangement
Table D-4 USB Port for Maintenance (Rear)
Pin Arrangement
D.3

SAS Port

The SAS port is used to connect external devices with an SAS interface, such as a tape
drive. The chassis has one SAS port on the rear.
Consult our service engineer about compatible equipment.
D.4 RESET Switch
The RESET switch is an emergency switch to reboot the XSCF. For details on how to
use the RESET switch, see "18.2 Precautions Concerning Using the RESET Switch"
in the Fujitsu SPARC M12 and Fujitsu M10/SPARC M10 System Operation and
Administration Guide.
Figure D-2
D-2) is mounted on the rear of the chassis.
Pin
Number
4
5
6
7
8
9
Pin
Number
1
4
2
3
2
3
1
4
shows the location of the RESET switch. The RESET switch (A in
Signal Input/Output
Name
GND ---
-SSRX Input
+SSRX Input
GND ---
-SSTX Output
+SSTX Output
Signal Input/Output
Name
VBUS Output
-DATA Input/
Output
+DATA Input/
Output
GND ---
Appendix D External Interface Specifications
Description
Ground
SuperSpeed data
SuperSpeed data
Ground
SuperSpeed data
SuperSpeed data
Description
Power supply
Data
Data
Ground
Figure
223