Incorporating The Hdd/Ssd - Oracle Fujitsu SPARC M12-1 Service Manual

Note - If the virtual function (VF) is lent to the logical domains by using the SR-IOV function,
the configuration of the virtual function may not be restored. Execute the ldm command to
manually restore the virtual function that was not restored.
The following is an example.
primary# ldm create-vf /SYS/PCI1/IOVNET.PF0
primary# ldm add-io /SYS/PCI1/IOVNET.PF0.VF0 ldom1
8. Execute the ldm add-spconfig command to save the logical domain
configuration information.
To save configuration information under the same name, execute rm-config to
delete it once, and then save it.
6.6

Incorporating the HDD/SSD

This section describes the flow of the procedure to incorporate a HDD/SSD by using
the hot plug function.
To use the hot plug function, the hotplug service of Oracle Solaris needs to be
enabled. Check the status of the service. If it is disabled, enable the hotplug service in
the following procedure. The hot plug function is available only on the control
domain and root domain.
# svcs hotplug ← If the STATE is disabled, enable the service.
# svcadm enable hotplug ← Enables the hotplug service.
For details on the cfgadm command used here, see "Chapter 2 Dynamically
Configuring Devices" in the Managing Devices in Oracle Solaris 11.2 or "Dynamically
Configuring Devices (Tasks)" in the Oracle Solaris Administration: Devices and File
Systems.
Log in as a super user to Oracle Solaris on the logical domain (control domain
1.
or root domain) into which the target HDD/SSD is to be incorporated.
2. If the hotplug service is disabled for the logical domain (control domain or
root domain) into which the target HDD/SSD is to be incorporated, execute the
svcadm enable command to enable the hotplug service.
# svcadm enable hotplug
3. Execute the cfgadm command to check the status of the incorporated HDD/SSD.
With the cfgadm -al command, confirm that the Ap_ID of the replacement
HDD/SSD has changed.
Confirm that Occupant shows "configured." If it does not show "configured,"
perform step 4.
88 Fujitsu SPARC M12-1 Service Manual • January 2023