Oracle Fujitsu SPARC M12-1 Service Manual page 135

Table 7-16 System-Stopped/Cold Removal Work Procedure
Item Work Procedure
1 Opening the rack door
2 Switching the mode switch on the
operation panel to Service mode
3 Checking the operating condition
of the system and the I/O device
usage status
4 Stopping the system
5 Removing the power cords
6 Removing the target FRU
7 Installing the power cords
8 Performing a diagnosis test
9 Confirming that there is no
problem with the reduced SPARC
M12-1
10 Returning the mode switch on the
operation panel to Locked mode
11 Starting the system
12 Closing the rack door
Reference
"5.2 Switching the Mode Switch to Service
"5.3 Checking the Operating Condition and Resource Usage
"5.5 Stopping the Entire
"5.8.1 Removing the Power
When removing a PCIe card:
"Chapter 8 Maintaining the PCI Express
When removing an HDD/SSD:
"Chapter 9 Maintaining Internal
"6.1.6 Installing the Power
"6.4 Diagnosing a Replacement
"6.7 Checking the FRU Status After
"6.8 Returning the Mode Switch to Locked
"6.9 Starting the System"
Mode"
System"
Cords"
Cards"
Storage"
Cords"
FRU"
Maintenance"
Mode"
Chapter 7 Maintenance Flow
Status"
121