Table of Contents
Advertisement
9.4
Installing an HDD/SSD
This section describes the procedure for installing an HDD/SSD. Use the same
procedure for expansion too.
Caution - Do not attempt to insert an HDD/SSD into a slot when the lever is closed.
Otherwise, the internal disk could jam and prove difficult to remove.
Note - In HDD/SSD expansion, to install an HDD/SSD in a slot, first remove the internal
storage filler unit from the slot.
1.
Open the lever and hold the HDD/SSD.
2.
Carefully insert the HDD/SSD into the slot.
Caution - Do not forcibly push the HDD/SSD into its slot. Using excessive force may
damage the HDD/SSD and server.
Secure the HDD/SSD by closing the lever.
3.
The FRU installation work is completed. See
continue maintenance work.
"Chapter 7 Maintenance
Chapter 9 Maintaining Internal Storage
Flow" to
135
Advertisement
Table of Contents
Troubleshooting
