Returning The Mode Switch To Locked Mode; Starting The System; Starting The System With An Xscf Command - Oracle Fujitsu SPARC M12-1 Service Manual

6.8 Returning the Mode Switch to Locked
Mode
Return the mode switch of the operation panel to Locked mode.
1.
For details, see
6.9

Starting the System

This section describes the procedure for starting the system.
The system can be started in either of the following two ways:

Starting the System With an XSCF Command

■
Starting the System From the Operation Panel
■
6.9.1 Starting the System With an XSCF Command
Confirm that the XSCF STANDBY LED on the operation panel is on.
1.
Log in to the XSCF shell.
2.
Execute the poweron command.
3.
Enter "y" in response to the confirmation message.
XSCF> poweron -a
PPAR-IDs to power on:00
Continue? [y|n] : y
00 : Powering on
Confirm that the POWER LED on the operation panel is on.
4.
Execute the showpparstatus command to confirm that the power to the
5.
physical partition is turned on.
XSCF> showpparstatus -p 0
PPAR-ID PPAR Status
00 Running
6. Execute the fmadm faulty command on the logical domains where an error is
detected to confirm that no errors remain.
# fmadm faulty
"2.3.2 Control Function of the Operation
Chapter 6 Understanding the Preparations for Restoring the System
Panel."
91