Restoring Setting Information And Configuration Information; Restoring Xscf Setting Information; Restoring Logical Domain Configuration Information And Openboot Prom Environment Variables - Oracle Fujitsu SPARC M12-1 Service Manual

6.5 Restoring Setting Information and
Configuration Information
6.5.1

Restoring XSCF Setting Information

This section describes how to restore the XSCF setting information saved on the USB
device in
1. Log in to the XSCF shell.
2. Execute the restoreconfig command to restore the XSCF setting information.
XSCF> restoreconfig -V file:///media/usb_msd/backup-file.txt
For details, see "10.10 Saving/Restoring XSCF Settings Information" in the Fujitsu
SPARC M12 and Fujitsu M10/SPARC M10 System Operation and Administration Guide.
6.5.2 Restoring Logical Domain Configuration
Information and OpenBoot PROM Environment
Variables
Reflect the setting of the XML file saved in
Configuration Information and OpenBoot PROM Environment
the shutdown command, and restart the control domain.
The following shows the procedure for restoring the saved logical domain
configuration information.
1. Confirm that the current logical domain configuration is factory-default.
primary# ldm list-config | grep "factory-default"
factory-default [current]
If [current] does not appear beside "factory-default," the current logical domain
configuration is not factory-default. In such a case, follow the procedure below
to change the current logical domain configuration to factory-default.
a. Execute the ldm set-spconfig command with "factory-default" specified.
primary# ldm set-spconfig factory-default
b. Execute the poweroff command of the XSCF firmware and turn off the power
"5.6.1 Saving XSCF Setting
to the physical partition.
Chapter 6 Understanding the Preparations for Restoring the System
Information."
"5.6.2 Saving Logical Domain
Variables," execute
85