Table of Contents
Advertisement
accurately maintained by the server at all times, including during hardware replacement
activities.
The KIP includes the server product name, product part number (PPN), and product serial
number (PSN). The KIP is stored in the FRUID (field-replaceable unit identifiers) container of
the three server FRUs that are designated quorum members.
The quorum members include:
•
Disk backplane (DBP), designated as a primary quorum member.
•
Motherboard (MB), designated as a backup quorum member.
•
Power supply (PS), designated as a backup quorum member.
When a server FRU that contains the KIP is removed and a replacement component is
installed, the KIP of the replacement component is programmed by Oracle ILOM to contain
the same KIP as the other two components.
Note:
Only one of the quorum members can be replaced at a time. Automated updates
can be completed only when two of the three quorum members contain matching
key identity properties.
Required Service Tools
The server can be serviced with the following tools:
•
Antistatic wrist strap
•
Antistatic mat(s)
•
No. 2 Phillips screwdriver
•
Torx (6 lobe) T10, T15, T25, and T30 drivers
•
Torque driver 12 in-lbf with T20 Torx bit (processor and heatsink installation)
Related Topics
•
Tools and Equipment For Installation
Preparing the Server for Component Replacement
Note:
When you are replace the storage drives or power supplies, not all of the
procedures in this section are necessary. For more information, see the
replacement procedures for those components.
Before you can remove and install components that are inside the server, you must perform
the procedures in some or all of the following sections.
Chapter 3
Required Service Tools
3-3
Advertisement
Chapters
Table of Contents
