Bay Networks 5399 Manual page 94

Chapter 4 Setting Up RACs
Managing Remote Access Concentrators Using Annex Manager
4-20
If you select
Autodetect, PPP, ARAP, IPX
allow a RAC to determine modem speed automatically. If you select
CLI, Telnet, Dedicated, NDP,
modem speed automatically, Annex Manager does not change this
condition.
Line Control Box
The box defines flow control and line speed settings using the
Line Control
following boxes:
•
Modem Signals
a modem for flow control. When you select this button, the ports
and modem use DCD, DTR, and DSR signals.
• specifies the type of signals a RAC uses to control
Flow Control
data transfer. There are four choices:
• indicates that flow control is disabled.
None
• indicates that the modem and/or port use CTS/
Hardware
RTS signals.
• indicates that the modem and/or port use xon/xoff
Software
signals.
• displays if the RACs you selected have flow control
Other
set to a value that is not
select another setting here, you cannot select
• defines the baud rate of the asynchronous line between a
Speed
device and a RAC. The value you choose must match the
device's baud rate. For a port with a modem, the speed field is
typically set to the maximum speed that the modem supports
(e.g., 115200).
All RACs do not support all port speeds. Refer to your RAC
hardware guide for information
, or
SLIP
or and the RACs you chose are set to select
Rlogin
indicates whether the ports you selected will use
Hardware, Software
.
, Annex Manager does not
, or . If you
None
again.
Other
Serial,