Bay Networks 5399 Manual page 284

Appendix A RAC Parameters
speed
stop_bits
subnet_mask
sysContact
Managing Remote Access Concentrators Using Annex Manager
A-94
defines the baud rate of the asynchronous line between a device and a RAC. The
value you enter must match the device baud rate. If you want line speed to be
determined automatically, use the
If you enter
disabled
value here.
Not all RACs support all port speeds. Refer to your RAC hardware
guides for detailed information.
Type Async
Values 2000, 2400, 3600, 4800, 7200, 9600, 19200, 38400, 57600,
115,200, and others
Default 9600
Lists Async Port, Basic Async Port, Modem
specifies the number of stop bits for a port.
Type Async
Values
one, two, one-and-half, dynamic
Default
one
Lists
Async Port, Basic Async Port, Modem, Modem Internal
contains the RAC IP subnet mask. The subnet mask defines which portion of the
IP address is the network, subnet, and host. The parameter default is based on
the network portion of the RAC IP address. Setting this parameter incorrectly
can cause routing problems.
Type
RAC Only
Values
IP address
Default
0.0.0.0
Lists
RAC Only, Basic RAC
identifies the contact person for this managed node, including information on
how to contact this person.
Type
RAC
Default
n/a
Values
0 to 255 characters
Lists
RAC Only
parameter.
autobaud
in the autobaud parameter, you must enter a