Bay Networks 5399 Manual page 244

Appendix A RAC Parameters
ipx_frame_type
ipx_security
ixany_flow_control
keep_alive_timer
lat_key
Managing Remote Access Concentrators Using Annex Manager
A-54
defines framing used for IPX packets on the Ethernet interface.
Type
RAC
Values
raw802_3, ethernetII, ccitt802, ccitt802snap
Default
raw802_3
Lists
RAC Only, IPX
controls whether IPX security is enabled on the port.
Type
Async
Values
enabled or disabled
Default
disabled
Lists Async Port, IPX, Security
treats any input character as a start (XON) character if output was suspended by
a stop (XOFF) character.
Type Async
Values enabled or disabled
Default disabled
Lists Async Ports, Flow Control
specifies the number of seconds that can elapse between the transmission of
identification packets during times of network inactivity. This parameter works
only for the LAT protocol. The packets serve only as notices to remote nodes
that the host services are available.
Type RAC
Values 0 to 255 seconds
Default 20 seconds
Lists
RAC Only, LAT
restricts access to LAT-specific RAC commands, parameters, functions, and the
LAT protocol within the RAC. Each RAC requires a unique key value. You must
contact your supplier to obtain a LAT key. After you set the key, your system
administrator must reboot the RAC.
Type
RAC
Values
obtained from your supplier
Default
n/a
Lists
RAC Only, LAT