Bay Networks 5399 Manual page 252
Remote access concentrators using annex manager
Hide thumbs
Also See for 5399:
- Hardware installation manual (132 pages) ,
- Release note (108 pages) ,
- Configuration notes (50 pages)
Table of Contents
Advertisement
Appendix A
RAC Parameters
Managing Remote Access Concentrators Using Annex Manager
A-62
•
to indicate that a port has no connection. You should
unused
enter
if a port is not connected to a device.
unused
•
to specify that a port can perform as a network interface
slip
using SLIP. IP packets are encapsulated by SLIP.
•
to allow a port to communicate only with the host
dedicated
defined in the
dedicated_port
communicate via
Telnet
•
to specify that a port can perform as a network interface.
ppp
PPP IP packets are encapsulated by PPP.
•
to specify that a port can perform as a network interface
arap
using ARAP.
•
to allow a port to identify the incoming protocol of a
auto-detect
packet and to convert to IPX, PPP, ARAP or CLI.
•
to allow a port to detect whether packets are
auto-adapt
incoming or outgoing. For incoming packets, the port behaves
as if it were in
auto-detect
operates in
mode.
slave
•
to allow Novell dial-in, dial-out, and routing.
ndp
•
to allow dial-in Novell access.
ipx
•
to allow a port to communicate with a LAT host via the
connect
command. This option works with the
connect
parameter
dedicated_arguments
•
to allow a port to communicate via the
rlogin
This option works with the
•
to allow a port to communicate via the
Telnet
This option works with the
•
to allow a port to communicate via the
tn3270
This option works with the
parameter. The port can
or
but not via
,
rlogin
tn3270
mode. For outgoing packets, it
.
rlogin
parameter.
dedicated_arguments
Telnet
parameter
dedicated_arguments
tn3270
parameter
dedicated_arguments
or
.
connect
command.
command.
.
command.
.
Advertisement
Table of Contents
