Bay Networks 5399 Manual page 136

Chapter 5 Booting and Resetting RACs
Managing Remote Access Concentrators Using Annex Manager
5-6
• allows you to add your own text to the standard
Boot Message
boot message. The text you enter displays on every terminal
connected to the RACs you select for booting. You cannot use
this field if you selected the
The
Preferred Load Address
fields use the default addresses and image. If you select:
• A single RAC,
image.
• Two or more RACs with the same preferred load and dump
address and default image,
and image.
• Two or more RACs with different default values for load
or dump addresses and images,
message informing you about this condition and leaves the
fields blank.
• If you leave these fields blank
for
Preferred Load Address
for each RAC you selected.
Image
Boot Command Messages
The command sends a standard message to all terminals connected
boot
to the RACs you are booting. Message text depends on the options you
select. If you select:
• ,
Immediate Dump
includes the RAC names and an indication of shutdown. For
example, booting a RAC named "Emma" sends the following
message:
***Annex
SNMP@network manager***
• the message contains the boot time and amount of time
Delayed
until the boot takes place. For example, if you schedule a boot
for 11:50 a.m. on Thursday, the message reads
shutdown message from NA by SNMP@network manager
(emma) going down in 57 minutes (11:50 Thu).
option.
Quiet
,
Preferred Dump Address
displays the default addresses and
Boot
displays these addresses
Boot
Boot
Boot
,
Preferred Dump Address
, , or
Diagnostic Save in Flash
(
emma) shutdown message from NA by
.
, and
Boot Image
displays a warning
uses the default value
and
Boot
the message text
(
***Annex emma)
***
Annex