Bay Networks 5399 Manual page 198

Appendix A RAC Parameters
bidirectional_modem
broadcast_addr
broadcast_direction
bypass
Managing Remote Access Concentrators Using Annex Manager
A-8
allows you to transmit and receive data after connecting to an asynchronous port.
When you choose
disabled
cannot occur until the Data Carrier Detect (DCD) modem signal is active. This
parameter is obsolete in Release 10.1.A and in subsequent releases.
Type
Async
Values
enabled or disabled
Default disabled
Lists Async Port, Flow Control, Modem
specifies the IP address for RAC broadcasts (network.255 or network.0).
Type RAC
Values IP Address
Default 0.0.0.0
Lists RAC Only, Basic RAC
controls the direction in which a RAC sends an administrative broadcast
message. When you choose
side of the connection. If you choose
You can use this parameter only when the
Type Async
Values port or network
Default port
Lists
Async Port, Basic Async Port, Modem
removes the T1 engine from the network. You should enter
first install a RAC or when the T1 engine is not functioning properly.
Type
T1 DS1
Values
enabled or disabled
Default
disabled
Lists
DS1 Line, T1_DS1
, you can connect to the port, but communication
, the RAC sends a message from the network
network
, it sends a message from the port side.
port
parameter is set to
mode
.
slave
when you
enabled