Bay Networks 5399 Manual page 225

CallDef_slip_tos
CallDef_tcp_keepalive
CallDef_Telnet_crlf
CallDef_Telnet_escape
allows a RAC or an ISDN Primary Rate RAC to send interactive traffic (such as
, , and
Telnet rlogin ftp
provides a type-of-service based SLIP queuing.
Type
RAC
Values
enabled or disabled
Default
disabled
Lists RAC Only, SLIP, Call Defaults
specifies the length of time a RAC or an ISDN Primary Rate RAC connection
must be idle before sending keep-alive messages. A keep-alive message contains
no data, but solicits an acknowledgment from the other end of a connection to
determine whether the connection is still active. If the recipient does not
acknowledge the message after eight retries, the RAC drops the connection. You
can use (the Annex Manager default value) to set the keep-alive time to 120
0
minutes, or you can enter
Type RAC
Values 0 to 255 minutes
Default 0 minutes
Lists
RAC Only, Basic RAC, Call Defaults
converts a carriage return in a Telnet session to a carriage return followed by a
line feed. If you enter
followed by a null string.
Type
RAC
Values
enabled or disabled
Default
disabled
LIsts
RAC Only, Cmd Line Editing, Call Defaults
defines the character that returns a CLI user to the
and enter to disable the
U
Ctrl
Type
RAC
Values
+ any character
Ctrl
Default
+
Ctrl ]
Lists RAC Only, Cmd Line Editing, Call Defaults
Managing Remote Access Concentrators Using Annex Manager
control sessions) before it sends other traffic. This parameter
to disable the keep-alive mechanism.
255
, a carriage return translates to a carriage return
disabled
escape character.
Telnet
(displays as ^])
Appendix A RAC Parameters
prompt. You can press
Telnet
A-35