Bay Networks 5399 Manual page 224

Appendix A RAC Parameters
CallDef_slip_mtu_size
CallDef_slip_no_icmp
CallDef_slip_ppp_
security
CallDef_slip_subnet_
mask
Managing Remote Access Concentrators Using Annex Manager
A-34
sets the maximum transmission unit (MTU) size for a PPP SLIP/CSLIP
connection to a RAC or an ISDN Primary Rate RAC. This parameter forces the
SLIP interface to use large (1006) or small (256) MTUs.
Type
RAC
Values
large or small
Default
small
Lists RAC Only, SLIP, Call Defaults
discards ICMP packets directed to the SLIP link. This parameter allows the ISDN
Primary Rate RAC to reduce unnecessary traffic and messages over the SLIP
link.
Type RAC
Values enabled or disabled
Default disabled
Lists RAC Only, SLIP, Call Defaults
controls dial-up SLIP/PPP access to a RAC or an ISDN Primary Rate RAC.
When and
enable_security
calls use the ACP security server. The RAC determines whether CLI users are
authorized to execute SLIP or PPP commands.
Type RAC
Values enabled or disabled
Default
disabled
Lists
RAC Only, PPP, SLIP, Security, Call Defaults, Sync Call
Defaults
contains the PRI RAC IP subnet mask for a SLIP interface. The subnet mask
defines which portion of the IP address is the network, subnet, and host. The
parameter default is based on the network portion of the RAC IP address. Setting
this parameter incorrectly can cause routing problems.
Type
RAC
Values
IP address
Default
0.0.0.0
Lists
RAC Only, SLIP, Call Defaults, Sync Call Defaults
are set to
CallDef_slip_ppp_security
, SLIP and PPP
enabled