Bay Networks 5399 Manual page 282

Appendix A RAC Parameters
short _ break
slip_allow_dump
slip_load_dump_host
slip_mtu_size
Managing Remote Access Concentrators Using Annex Manager
A-92
allows a RAC to return a user to the CLI prompt after receiving a break of less
than two seconds.
Type
Async
Values
enabled or disabled
Default
disabled
Lists
Async Port, Idle Timer
enables a RAC to dump its operational code across a SLIP link.
Type
Async Port
Values
enabled or disabled
Default enabled
Lists Async Port, SLIP
contains the IP address of the host from which a RAC receives a load or to which
it sends dumps over the SLIP interface. If you entered
, you must enter a valid address here. This parameter value
load_dump_sequence
overrides values in
pref_load_addr
Type Async
Values IP address
Default 0.0.0.0
Lists Async Port, SLIP
sets the maximum transmission unit (MTU) size on a SLIP/CSLIP port. This
parameter forces the SLIP interface to use large (1006) or small (256) MTUs.
Type Async
Values large or small
Default
small
Lists
Async Port, SLIP
sl
and .
pref_dump_addr
and a number in