Chapter 5
Booting and Resetting RACs
Managing Remote Access Concentrators Using Annex Manager
5-10
•
resets the parallel printer ports.
All Printer Ports
•
resets the virtual connections.
All Virtual Ports
•
All T1 DS1 Ports (Hard)
T1 Drop/Insert interface and modem sessions
•
All T1DS1 Ports (Soft)
on DS0 channels that were changed.
•
resets all T1 engine statistics.
All ESF Counters
•
resets the interface parameters.
All Interfaces
•
All Internal Modems
•
resets only the port type you enter in the option
Individual Ports
button below the
Reset Option
enter in the adjacent field.
•
Individual Internal Modems
you enter in the option button below the
the modem numbers you enter in the adjacent field.
•
resets entries used for dialing out from a UNIX host to a
Dialout
remote node over a port in slave mode.
•
resets LAT (Local Area Transport) parameters. When you
LAT
use this option, existing connections keep their current values:
new parameter values apply only to LAT connections
established after using
•
resets macros after you customize them in the RAC
Macros
configuration file.
•
Message of the Day
when you establish a connection to a RAC.
•
resets modem entries for external modems only.
External Modem
•
resets a PRI line for an ISDN Primary Rate RAC.
PRI Line
•
reloads session parameter blocks in the
PRI Sessions
configuration file for an ISDN Primary Rate RAC session.
•
resets the parameters and host table that enable a
Name Server
RAC to translate addresses to names.
•
resets security parameters.
Security
resets the T1 engine and terminates the
resets parameters and disrupts service only
resets entries for internal modems only.
box and the port numbers you
resets one or more internal modems
Reset Option
.
Reset
resets the file for the message that appears
.
box and