Bay Networks 5399 Manual page 200

Appendix A RAC Parameters
CallDef_at_nodeid
CallDef_at_security
CallDef_attn _ string
Managing Remote Access Concentrators Using Annex Manager
A-10
specifies the Appletalk hint used by a RAC or an ISDN Primary Rate RAC . You
can enter an ID in decimal or hexadecimal notation. Each ID has two parts
separated by a dot:
• A network address ranges from 0 to 65534 (0x0000 to
0xFFFE).
• A node address ranges from 0 to 255 (0x00 to 0xFE).
For example, ,
191.253 0x00BF.253
Type
RAC
Values
0 to 65534.255
Default
0.0
Lists
RAC Only, AppleTalk, Call Defaults
turns on ACP service for an AppleTalk session. When you choose
this parameter and for
enable_security
get security information about the client, including authentication, logging, and
zone access information. If you choose
uses only local security.
Type RAC
Values enabled or disabled
Default disabled
Lists RAC Only, AppleTalk, Call Defaults
defines a control character sequence that returns users to the CLI prompt. Users
can define a Annex Managerrary control character sequence using the CLI
command.
attn
Type
RAC
Value
+ any character, up to 16 characters
Ctrl
Default
" " (null string) or
Lists RAC Only, Cmd LIne Editing, Modem, Modem Internal,
Call Defaults
and designate the same address.
191.0xFD
, the ISDN Primary Rate RAC uses ACP to
, the ISDN Primary Rate RAC
disabled
+
(for vcli connections)
Ctrl A
for
enabled
stty