16 =15,15,7,7 Model 5399 RAC Digital Modem Configuration Notes his document describes parameters used to configure the 5399 Parameters 26 through 63 are provided for use by qualified modem engineers only. Changing these parameters from their default settings could cause unexpected negative results, and is discouraged.
Setting Parameter Values In this example, when the 5399 RAC receives a call on a number that ends with 103, the call is treated as a modem call, with a user-defined modem type named credit_card. Before the modem answers the call, its digital modem configuration parameters 16, 17, 18, and 19 are set to the values 15, 15, 7, and 7, respectively.
Modulation - V34+ (bit rates up to 33.6Kbps) (Default) Parameter 30: A/ : Compander Type 1 - U.S. Operation, V.42bis Primary/MNP5 Secondary This is the digital modems’ default configuration. No config_bytes entries are needed to enable this configuration. (mu) law (Default) Model 5399 RAC Digital Modem Configuration Notes...
Leave all parameter options set to their default values except: Parameter 0: L: LAPM - Disabled (Not Default) required config_bytes setting: config_bytes 0 =4 Model 5399 RAC Digital Modem Configuration Notes Although other parameters affect V.42 operation, only parameter 0 needs to be changed to disable V.42 operation completely.
All settings are listed as binary values. Unused and reserved bits are shaded in the parameter maps. U.S. Operation, Disable V.34 Extended Speeds (33.6 Kbps) Model 5399 RAC Digital Modem Configuration Notes...
Table 1 and Table 2 below describe how the modem handles a break character: 0: Disable - Will not forward a break 1: Destructive/Expedited 10: Nondestructive/Expedited 11: Nondestructive/Nonexpedited Model 5399 RAC Digital Modem Configuration Notes Parameter 1 2 1 0 1 0 1 Reserved...
Page 14
All state variables pertaining to control function and error control function operation, except those pertaining to break transfer, are reset to their initial values. DCE: Data Communications Equipment (MODEM) DTE: Data Terminal Equipment (PC) Model 5399 RAC Digital Modem Configuration Notes Going to local Coming from...
Page 15
0: Disable 1: Enable Going to Remote DCE Discard data not yet transmitted. No effect. No effect. Model 5399 RAC Digital Modem Configuration Notes Parameter 1 Going to local DTE Discard data not yet delivered. Deliver break signal. Deliver break signal immediately.
45 seconds. If a carrier is not received within this time, the modem hangs up and reports: Message: No carrier Disconnect reason: CD Timer Model 5399 RAC Digital Modem Configuration Notes Parameter 7 Reserved Wait CD Time...
This parameter is provided for cases where certain non-standard modems do not support all baud rates. 0: 2400 1: 2743 10: 2800 11: 3000 100: 3200 101: 3429 Model 5399 RAC Digital Modem Configuration Notes Parameter 20 Max RX baud Max TX baud...
Page 31
3429. Out of these, the first five can operate at high or low carrier frequencies. During channel probing, one of these two carrier frequencies is selected in order to optimize the channel bandwidth usage. 0: Low 1: High Model 5399 RAC Digital Modem Configuration Notes Parameter 26...
Decimal base: 3 Octal base: 03 Hexadecimal base: 0x3 D: Usb1 Early Detector - Detection of unscrambled binary ones supports V.34 modems under certain South American line conditions. 0: Disable 1: Enable Model 5399 RAC Digital Modem Configuration Notes Parameter 30 Reserved...
(a type of forward error correction) used by the modem receiver during V.34 connections. 0: Negotiable 1: 4D 16States 10: Reserved 11: Reserved T: v32 9600 Trellis Coding - Enables/disables trellis coding at 9600 bps. 0: Disable 1: Enable Model 5399 RAC Digital Modem Configuration Notes Parameter 32 Reserved Reserved...
EP: Echo Protection Tone - When this option is enabled, the modem sends an unmodulated carrier signal prior to the training and data signals to disable the telephone network echo suppressor. 0: Disable 1: Short 10: Long 11: Reserved Model 5399 RAC Digital Modem Configuration Notes Parameter 35 Reserved...
31.2 Kbps. In addition, as in any situation where a downlink digital to analog conversion (PCM hop) is made, 56K (V.pcm) connections are not possible. 0 - Disable 1 - Enable Model 5399 RAC Digital Modem Configuration Notes Parameter 38 Reserved...
Need help?
Do you have a question about the 5399 and is the answer not in the manual?
Questions and answers