Appendix A
RAC Parameters
CallDef_max_sessions
CallDef_metric
CallDef_mode
Managing Remote Access Concentrators Using Annex Manager
A-22
specifies the maximum number of concurrent ISDN Primary Rate RAC
connections. Entering
-1
Type
RAC
Values
-1 to 16
Default
3
Lists
RAC Only, Basic Async Port, Call Defaults
defines the hop count to the remote end of the connection when
set to
or
. You should modify this parameter only if you want the ISDN
slip
ppp
Primary Rate RAC to use a route other than the SLIP or PPP interfaces to the
remote end.
Type
RAC
Values
1 to 15
Default
1
Lists
RAC Only, PPP, SLIP, Call Defaults
sets the mode for access to a RAC or an ISDN Primary Rate RAC. For more
information about modes, see the Managing Remote Access Concentrators Using
Command Line Interfaces. You can enter:
•
to allow a dialed terminal or incoming modem access to CLI.
cli
CLI provides access to the network and connections to other
hosts via the
Telnet
The
is set to an appropriate value.
•
to specify that a connection can perform as a network
slip
interface using SLIP. IP packets are encapsulated by SLIP.
•
to specify that a connection can perform as a network
ppp
interface using PPP. IP packets are encapsulated by PPP.
•
to specify that a connection can perform as a network
arap
interface using ARAP.
indicates that there is no maximum set.
and
,
,
connect
rlogin
command is available only when
tn3270
CallDef_mode
commands
.
tn3270
option_key
is