Bay Networks 5399 Manual page 291

tmux_enable
tmux_max_host
tmux_max_mpx
tni_circuit_id
controls whether a RAC uses TMux to multiplex small TCP or UDP packets into
a single IP packet. The host must support TMux. If you choose
host does not support TMux, the RAC does not support multiplexing.
Type
RAC
Values
enabled or disabled
Default
disabled
Lists RAC Only, TMux
specifies the maximum number of host addresses allowed in the TMux address
table. If the number of host addresses exceeds the number you enter here, the
RAC discards the oldest entry.
Type RAC
Values 10 through 255
Default 64
Lists RAC Only, TMux
specifies the largest user packet that can be placed in a TMux packet. The RAC
does not multiplex larger packets, but passes them directly to the IP layer.
Type RAC
Values 5 through 65535
Default 700
Lists RAC Only, TMux
contains the transmission vendor's circuit identifier used for customer service
calls.
Type T1 DS1
Values
0 to 128 characters
Default
" "
Lists
DS1 Line, T1_DS1
Managing Remote Access Concentrators Using Annex Manager
Appendix A RAC Parameters
and the
enabled
A-101