Bay Networks 5399 Manual page 204

Appendix A RAC Parameters
CallDef_def_session_
mode
CallDef_dialup_
address_origin
Managing Remote Access Concentrators Using Annex Manager
A-14
defines the default session mode when the DECServer command interface is
configured (i.e., when
CallDef_cli_interface
refer to the Annex Interface for VMS Environments Administrator's Guide.
Type
RAC
Values
interactive, passthru, passall, transparent
Default
interactive
Lists RAC Only, Call Defaults
allows a RAC or an ISDN Primary Rate RAC to search the
user name of the remote client and to set local and remote addresses. This
parameter applies only when the
• :
acp_dialup
– If the file contains a matching user name and:
• The local and remote addresses exist in the
file, the RAC uses those values.
• The the
not a local address, the RAC uses the remote address
from the file and the RAC IP address for the local
address.
– If the file does not contain a matching user name, the RAC
uses values from the
parameters:
• If both parameters contain addresses, the RAC uses
these values.
• If both parameters are set to
for both addresses with the remote PPP client. The
connection is denied for a remote SLIP client.
• If
local_address
set to
negotiates with the remote PPP client for the remote
address. The connection is denied for a remote SLIP
client.
is set to
parameter is set to
CallDef_mode
file contains a remote address but
acp_dialup
local_address
0.0.0.0
contains a value and
, the RAC uses the local address and
0.0.0.0
). For more information,
vci
file for the
acp_dialup
or
slip ppp.
acp_dialup
and
remote_address
, the RAC negotiates
is
remote_address