Bay Networks 5399 Manual page 238

Appendix A RAC Parameters
forwarding_count
forwarding_timer
group_value
Managing Remote Access Concentrators Using Annex Manager
A-48
controls RAC port behavior for received characters. If you enter a number other
than , the port does not forward characters until it receives the number of
0
characters you entered. If you enter
you use
forwarding_count
that occurs first.
Setting
forwarding_count
effect on the network when heavy serial input occurs.
Type Async
Values 0 to 255
Default 0
Lists Async Port, Idle Timer
sets the amount of time in ten millisecond intervals that can elapse before a RAC
forwards received data. If new data arrives before the timer expires, the RAC
resets the timer. If you enter
default value.
Setting
forwarding_count
effect on the network when heavy serial input occurs.
Type Async
Values 0 to 255 tens of milliseconds
Default 5 (50 milliseconds)
Lists Async Port, Idle Timer
specifies the LAT protocol remote group codes that can access local services
offered by a RAC. To access these services, the RAC must have at least one
enabled group code that matches the group codes of the service. You can enter
, , a series of numbers separated by commas, (e.g.,
all none
numbers separated by dashes (e.g.,
Type
RAC
Values
all, none, or numbers from 0 to 255
Default
none
Lists
RAC Only, LAT
, the port uses values in
0
and parameters, the RAC uses the value
forwarding_timer
to or
1
forwarding_timer
, the RAC uses , which is the Annex Manager
0 5
to or
1 forwarding_timer
1, 5, 200-255
forwarding_timer
to can have a severe
0
to can have a severe
0
, , ) or a range of
1 5 7
).
. If