Bay Networks 5399 Manual page 279

rip_sub_advertise
routed
rts_signal
controls whether the RAC advertises subnet routes over the SLIP, PPP, and
Ethernet interfaces.
Type
Interface
Values
enabled or disabled
Default
disabled
Lists
Enet Port, Async Port, Routing
determines whether the RIP routing daemon is enabled. When you enter
the RAC performs active RIP routing only if
If is not set correctly, the RAC performs passive RIP routing when the
option_key
daemon is enabled. If you enter
If you disable the RIP routing daemon and the RAC does not reside
on the same subnetwork as the Annex Manager host, you cannot
contact the RAC after you reboot the RAC or after you reset the
routing subsystem.
Type RAC
Values enabled or disabled
Default enabled
Lists RAC Only, Basic RAC, Routing
controls the RTS (Request to Send) signal for the port. Entering a value for an
idle port produces an error condition.
If you change the value for this parameter and then reset a port
or reboot a RAC, the parameter returns to its original default value.
Therefore, you must choose
window to prevent the reset process and to use the parameter
values you entered.
Type Async
Values unknown, high, low
Default unknown
Lists Async Port
Managing Remote Access Concentrators Using Annex Manager
Appendix A
is set to the correct value.
option_key
, no RIP routing occurs.
disabled
in the
Cancel
RAC Parameters
,
enabled
Reset Parameters
A-89